Pen-y-Fron Mine

Also known asBryncelyn Mine, Bryncelyn West, West Bryncelyn Mine, Penyfron Mine
LocationRhydymwyn, Flintshire — 53.1868, -3.2017 (exact)
CommoditiesLead, Silver, Zinc
TypeMetal
WorkedBy 1786–1913
OperatorsRichard Ingleby (1786–?, owner)
John Taylor (1824–1845, manager) — The Mold Mines amalgamated under John Taylor, 1824-45.
Brunner, Mond and Company Ltd (1900–1902, owner) — Owned the West Iron Shaft site at the eastern end of the vein, 1900-02.
South Halkyn and Rhydymwyn Mining Company Ltd (1901–1911)

Pen-y-Fron, or Bryncelyn, was a lead, silver and zinc mine on the Alyn gorge near Rhydymwyn, worked from the 1780s to 1913. John Taylor's Mold Mines gave it big pumping engines.

Location

Recorded location. The large pin is this mine; the small round markers are the nearest mines on record. Click one for its page. View on full map

History

Pen-y-Fron, also known as Bryncelyn, worked the Bryncelyn Lode, which runs east from the River Alyn at Nant Alyn across a limestone ridge towards the foundry at Rhydymwyn. Richard Ingleby owned the mine in 1786 and built the Penyfron smelt beside the Alyn, its smelting houses driven by two waterwheels, with a mill nearby that rolled lead into sheet. By 1798 a 60-inch Newcomen engine was pumping at the Old Engine Shaft, alongside three waterwheels.

Between 1824 and 1845 most of the mines of Mold Mountain were brought together under the mining engineer John Taylor, and the Mold Mines spent heavily on engines, pumps and leats. Taylor's records for 1825-30 list a 66-inch engine on the Old Engine Shaft, a 64-inch engine on Bryncelyn Shaft and a 63-inch engine put up on Taylor's Shaft in 1827, with 44-foot waterwheels at Waterwheel Shaft and Wheel Shaft; at the Rhydymwyn end a 46-inch engine also worked a whim across the river by rods. A leat about two metres wide, partly cut from the rock and partly walled, fed the dressing floors. A section of the lode published in 1921 names its shafts from East Iron and West Iron through Bryn's, Whim, Wheel, Rundee, Davey's, Dyer's and Taylor's to Bryncelyn, Old Engine and Waterwheel. The eastern end of the vein, in gravel and shale, is the only place where ore was raised in quantity from the Lower Coal Measures.

In October 1874 the foundation stone of a new engine house was laid at the West Bryncelyn Mine, and its shareholders celebrated with a dinner at the Antelope Inn in Mold. Brunner Mond and Co owned the West Iron Shaft site in 1900-02. In 1901 the South Halkyn and Rhydymwyn Mining Company, which had stopped work at its Charlton Shaft, told its shareholders that it would turn to the Bryncelyn section, where it had made a substantial discovery, although the low price of lead had stopped it selling ore that year. In April 1911 George Jones, a shot-lighter for that company, died from breathing the fumes after going back to the face again and again once charges of blasting gelatine had been fired. The mine was drained by a level from the Alyn and later by the Halkyn drainage level, and work ended in 1913.

Geology

The Bryncelyn Lode crosses Carboniferous Limestone and Cefn-y-fedw Sandstone; its eastern end runs through alluvial gravel and shale and yielded ore from the Lower Coal Measures. Lead, silver and zinc ores were raised.

Workings

A line of shafts along the Bryncelyn Lode from the crest of the limestone ridge down to the River Alyn and east to Rhydymwyn, with an adit level, waterwheel pits, leats and stepped dressing floors; drained by a level from the Alyn and later by the Halkyn drainage level. Twentieth-century workings lie in Coed Bryncelyn.

Closure

Worked by the South Halkyn and Rhydymwyn Mining Company in the 1900s; work ended in 1913.

What remains

Woodland and rough pasture on the side of the Alyn gorge. The limestone retaining walls of the stepped dressing floors near Pen-y-Fron cottage were in very good condition in 1993, and well preserved stretches of the leat survive.

Rubble-filled and fenced shafts with engine and whim platforms, a collapsed adit, the waterwheel pit, the leat, the dressing-floor walls, reservoir banks and a roofless one-room building thought to be the mine office.

Redevelopment

The woods of Coed Bryncelyn have grown over the later workings, and in 1993 one spoil area near the eastern end was being used as a dump for building materials.

Nearby mines

Straight-line distance, within 9 miles (15 km).

Further reading

Clwyd Metal Mines Survey: Pen-y-Fron (reference)

The trust's field survey of the Pen-y-Fron (Bryncelyn) workings, with John Taylor's engine lists, the leat and the dressing floors.

View source

Sources

  1. (secondary) Clwyd Metal Mines Survey: Pen-y-Fron (HER 103159) — Clwyd-Powys Archaeological Trust, Clwyd Metal Mines Survey
  2. (primary) Penyfron Mine; Bryncelyn Mine (NPRN 33950) — Coflein (RCAHMW)
  3. (secondary) Mold: the Flintshire mines; new engine house at the West Bryncelyn Mine (Wrexham Advertiser, 10 October 1874) — Welsh Newspapers Online (National Library of Wales)
  4. (secondary) Mining company meeting: South Halkyn and Rhydymwyn (Chester Courant, 18 December 1901) — Welsh Newspapers Online (National Library of Wales)
  5. (secondary) NMRS mining deaths database: George Jones, Bryncelyn, 1911 — Northern Mine Research Society
  6. (primary) Mine plan: Pen-y-Fron and Rhyd-y-mwyn (Brick, Bryn Celyn, Cooke's, Davey's, Dyer's, Iron, Nell's ... shafts) (MRA OMR121E) — British Geological Survey / Mining Remediation Authority

Record created: 21 November 2026 · Last researched: 21 November 2026

Accessibility options

Saved in this browser and applied on every page. Colour is never the only cue on MineArchive; if links are hard to pick out, underline them or raise the contrast. For larger text, use your browser's zoom.

Contrast
Link visibility
Motion
Reading width