Mynach Vale Mine

Also known asTygwyn Mine, Ty Gwyn Mine, De Broke Mine, Dolwen Mine
LocationJunction of the Rhuddnant and Myherin streams, nearly 3 miles from Devil's Bridge, Ceredigion — 52.3818, -3.8055 (exact)
CommodityLead
TypeMetal
WorkedBy 1874–1880s
Maximum depth50 fathoms below the shallow adit (about 91 m)

Mynach Vale, or Tygwyn, was a lead mine where the Rhuddnant and Myherin streams meet to form the Mynach, nearly three miles above Devil's Bridge. It was worked in the 1870s and 1880s from two shafts, the deeper sunk 50 fathoms below a shallow adit. It returned 194 tons of lead ore under its own name, and most of the 831 tons credited to 'De Broke or Dolwen' probably came from here too.

Location

Recorded location. The large pin is this mine; the small round markers are the nearest mines on record. Click one for its page. View on full map

History

There are two workings on what is taken to be one lode. Dolwen stands on the spur between the Myherin and Mynach valleys at nearly 1,400 feet, far from any road, and was worked from an inclined shaft on the summit. Half a mile to the south-west, down by the river, the lode enters the Tygwyn property, and there the Mynach Vale mine was sunk.

Which of them was the mine called De Broke has never been quite settled. A mining writer of 1874 described Mynach Vale under that name; the official statistics from 1877 list 'De Broke or Dolwen'. Lead ore was returned as De Broke for ten years, 831 tons in all with a best year of 221 tons in 1877, yet Dolwen by itself is credited with only 3 tons, and its workings are too slight to have given the rest. The likelier reading is that De Broke was Mynach Vale.

Under its own name Mynach Vale returned ore for six years, 194 tons, the best of them 1882 with 96 tons. Ore was found in most of its levels to the bottom of the mine, the best ground lying at the east end.

Geology

The lode dips south-east at about 65 degrees through beds high in the Frongoch formation. Near the river it carries a good deal of blende and copper pyrites with calcite beside the galena; these are absent on the hilltop at Dolwen, where the lode is several feet of brecciated mudstone and quartz, and the Dolwen workings may be on a branch. The same lode probably runs on south-west to Bodcoll.

Geological setting: Veins and Lodes (well documented example)

Workings

Mynach Vale has two shafts. The western is sunk on the lode to 25 fathoms; the eastern, by the mine buildings, goes down vertically 50 fathoms below a shallow adit at about 850 feet above sea level. At Dolwen an inclined shaft on the summit was partly drained by a shallow adit, and near the river there are old shafts and an adit at about 870 feet.

Closure

The best year under the name Mynach Vale was 1882, and the mine was worked around 1880; no later return is recorded.

Nearby mines

Straight-line distance, within 9 miles (15 km). Show on the map.

Further reading

Coflein: Dolwen Mine; De Broke Mine; Mynach Vale Mine (reference)

The Royal Commission's brief site record, which gathers all four names under one entry.

View source

Sources

  1. (primary) Lead and Zinc: The Mining District of North Cardiganshire and West Montgomeryshire (Special Reports on the Mineral Resources of Great Britain, vol. XX), O. T. Jones, 1922 — Memoirs of the Geological Survey
  2. (primary) Dolwen Mine; De Broke Mine; Mynach Vale Mine; Ty Gwyn Mine (NPRN 420381) — Coflein, Royal Commission on the Ancient and Historical Monuments of Wales
  3. (primary) Mine plan: Mynach Vale or Tygwyn Mine, SN77NE 4, location of mine (KP17008) — British Geological Survey

Record created: 18 November 2026 · Last researched: 18 November 2026

Accessibility options

Saved in this browser and applied on every page. Colour is never the only cue on MineArchive; if links are hard to pick out, underline them or raise the contrast. For larger text, use your browser's zoom.

Contrast
Link visibility
Motion
Reading width